Prime the 3" part of the 3" to 1 1/5" reducer and the outside of the small piece of 3" pipe
Glue the small piece of pipe into the reducer. Make sure that you leave half of the pipe outside of the reducer.
Prime the cleanout plug and all the openings on the tee.
Glue the part of the 3" pipe that is sticking out of the reducer into one of the 3" openings of the tee.
Glue the cleanout plug into the other 3" opening of the tee.
Prime the outside of the small piece of 1 1/5" pipe.
Glue the pice of 1 1/5" pipe into the remaining opening of the tee. Make sure to leave half of it sticking out the opening.
Prime the inside of the 1 1/5" end cap.
Glue the end cap onto the other half of the piece of 1 1/5" pipe.
Prime one end of the long piece of 1 1/5" pipe and the 1 1/5" opening of the reducer.
Glue the pipe into the reducer.
Drill a hole into the end cap that is large enough for the long part of the ignitor to fit in but not the black base. Glue the ignitor into the endcap using a hot glue gun.
